AT90USBxxx USB Mass storage

License

Use of this program is subject to Atmel's End User License Agreement.

Please read file LICENSE.TXT for copyright notice.

Description

This embedded application source code illustrates how to implement a USB mass storage application over the AT90USBxxx controller.

About the sample application

By default the sample code is delivered configured for STK525, but this sample application can be configured for both STK525 or AT90USBKey hardware, see TARGET_BOARD define value in config.h file.

Revision

V2.0.2

USB Stack :

• Improve USB protocol for USB chap9 and MSC compliance

V2.0.1

USB Stack:

• Improve USB protocol for USB chap9 and MSC compliance
• Move VBus interrupt to VBus pooling
• Fix USB constant about Device Status
• Add three possibilities for SN on USB : No SN, Constant SN, Unique SN
• clean stack constant
• Fix inquiry command
• clean and fix specific request

DataFlash driver:

• Add USB Write Protection management on DataFlash
• Fix error on DataFlash I/O initialization

New watchdog driver to control the specific sequence timing

V2.0.0 and before

First releases

About the source code

This source code is usable with the following compilers:

• IAR Embedded Workbench (5.11A and higher)
• AVRGCC (WinAVR 20080411 and higher).

Support for other compilers may required modifications or attention for:

• compiler.h file
• special registers declaration file
• interrupt subroutines declarations

Architecture

As illustrated in the figure bellow, the application entry point is located is the main.c file. The main function first performs the initialization of a scheduler module and then runs it in an infinite loop. The scheduler is a simple infinite loop calling all its tasks defined in the conf_scheduler.h file. No real time schedule is performed, when a task ends, the scheduler calls the next task defined in the configuration file (conf_scheduler.h).

The sample dual role application is based on two different tasks:

• The usb_task (usb_task.c associated source file), is the task performing the USB low level enumeration process in device mode.
• The storage task performs SCSI bulk only protocol decoding and performs flash memory access.

---